Page 1 of 1

Got my AG71/Gorilla cases in today!

Posted: Wed Mar 16, 2016 2:29 pm
by DBMcCann
Couldn't pass up that deal. I just got shipment of my internals, so I thought I'd share a photo or two.

Nozzles and bulkheads are from Dan Patell, Cases are from AG71, thrust and snap rings from McMaster (going to need a bit of grinding). Currently going to share nozzle washers until I can get some more of those. Went with 28 for the 54/1050, 36 for the 54/1750, and 44 for the 54/2550 on the nozzles.

Image


And with all my 54mm snap rings. Loki 54/1200, 54/1050, Loki 54/1600, nozzle for a 54/1750 still on it's way to me, and the 54/2550. (again no nozzle washers installed yet on the AG71 cases)

Image

Re: Got my AG71/Gorilla cases in today!

Posted: Wed Mar 16, 2016 3:00 pm
by DBMcCann
Image
Image
Image

Re: Got my AG71/Gorilla cases in today!

Posted: Sun Mar 20, 2016 7:20 pm
by DBMcCann
Little time with the dremel and a file and we've got the 2550 fitting into an aeropack.

Image



Image

Re: Got my AG71/Gorilla cases in today!

Posted: Sun Mar 20, 2016 8:37 pm
by JD13x
If they are all the same spec as AMW then, how come my AMW spiral rings won't fit into Aero pack retainers?
AMW's do without any mods??

Re: Got my AG71/Gorilla cases in today!

Posted: Sun Mar 20, 2016 9:00 pm
by DBMcCann
Not sure what you mean.... But these were mcmaster carr rings i installed.... then ground quite a bit to fit into the aeropack.